User Guide

34
9.7 Forward-Stop-Reverse
Switch Connection
(CON2) –
To operate the
drive using a Forward-
Stop-Reverse Switch,
remove the factory
installed jumper on CON2
and install the 3-wire con-
nector (supplied). CON2
is located on the lower
PC board. The connector
must be wired to a “main-
tained” switch or contact.
See Figure 20. Also see
Forward/Reverse Speed
Selection
, in Section 6.4,
on page 27.
Note: The drive can be
factory programmed for
momentary contact
operation.
9.8 Enable Switch
Connection (CON2) –
The drive can be started and stopped with an Enable Switch (close to run, open to stop).
Remove the factory installed jumper on CON2 and install the 3-wire connector (supplied).
CON2 is located on the lower PC board. The connector must be wired to a “maintained”
switch or contact. See Figure 21, on page 35.
FIGURE 19 – MANUAL START SWITCH CONNECTION
Jumper Removed
Connector Installed for
Manual Start Switch
CON1
A/M
Manual Start Switch
(Momentary Contacts)
(Push to Run)
White
Black
CON1
FIGURE 20 – FORWARD-STOP-REVERSE SWITCH CONNECTION
Jumper Removed
Connector Installed for
Forward-Stop-Reverse Switch
CON2
F - S - R
Forward-Stop-Reverse
Black
White
CON2
Red
Stop
Forward
Reverse
Switch