User Guide

12
Note: Disconnect main power when installing or changing the Plug-In
Horsepower Resistor®.
III. WIRING INSTRUCTIONS
Warning!
Read Safety Warning, on page 5 before using this control.
Disconnect the AC line before wiring.
Note: To avoid erratic operation, do not bundle AC line and motor wires with wires
from signal following, Start/Stop Switch, Enable, or any other signal wires. Use
shielded cables on all signal wiring over 12” (30cm). Shield should be earth ground-
ed on the control side only. Wire the control in accordance with the National
Electrical Code requirements and other codes that may apply to your area. See
Figure 4 on page 13.
Be sure to properly fuse each conductor that is not at ground potential. Do not fuse
neutral or grounded conductors. See Section VIII, on page 18. A separate AC line
switch or contactor must be wired as a disconnect so that each ungrounded con-
ductor is opened. See Application Note, Section VII, on page 18.
0.18
SCR Rated Motor
Horsepower Ranges (HP)
PWM Rated Motor
Horsepower Ranges (HP)
Motor
Current
(Amps DC)
9836
3.3 – 5.0
Plug-In
Horsepower Resistor®
90 Volt DC 180 Volt DC 130 Volt DC 200 Volt DC Ω Part No.
9949
1/3 – 1/2
1/4
0.1
0.25
0.51
1
2.0
9838
9837
9834
9833
3/4 – 1
1/100 – 1/50
1/2
1/15 – 1/10
1/8 – 1/6
1/30 – 1/20
1/4 – 1/3
1/6 – 1/5
1/15 – 1/10
1/50 – 1/25
1/2 – 3/4
1/3
1/6 – 1/4
1/12 – 1/8
1/20 – 1/15
1/50 – 1/30
1 – 1
1
⁄2
3/4
1/3 – 1/2
1/6 – 1/4
1/8 – 1/6
1/25 – 1/20
2.5
1.3 – 2.0
0.7 – 1.0
0.4 – 0.6
0.1 – 0.3
TABLE 3 – PLUG-IN HORSEPOWER RESISTOR® SELECTION
Notes: 1) 1 HP = 0.75 kW. 2) The HP marking on the Plug-In Horsepower Resistor® does not apply to PWM controls.
!
CL Setting
(Amps DC)
0.5
7.5
3.8
3.0
1.5
0.9
!