User Guide

Warning! Do not wire switches or relays in

series with the armature. Armature switching

can cause catastrophic failure of motor and/or control.

A. AC Line Connection – Wire the AC line to L1

and L2 terminals, as shown in Figure 4.

B. Permanent Magnet (PM) Motor Connection –

Wire the motor armature leads to A+ and A- termi-

nals, as shown in Figure 4. On dual voltage mod-

els, be sure that Jumper J1 is set to the corre-

sponding motor voltage. Be sure that the correct

Plug-In Horsepower Resistor® is installed (see

Table 3, on page 12).

Note: If the motor runs in

the opposite direction than is desired,

disconnect power and reverse the motor

leads.

C. Main Speed Potentiometer

Connection – The control is supplied

with a Main Speed Potentiometer.

Connect the Main Speed Potentiometer

high side to P3 terminal, wiper to P2

terminal and low side to P1 terminal, as

shown in Figure 5. Rotating the Main Speed Potentiometer clockwise will

increase motor speed. Rotating the Main Speed Potentiometer counterclock-

wise will decrease motor speed.

D. Voltage Following Connection – A 0 - 5 Volt DC analog signal voltage can

also be used to control motor speed. See Figure 6, on page 14. Connect the

MOTOR

–

AC LINE

A- A+

FIGURE 4 – POWER

CONNECTIONS

P3 P2 P1

WIPER (ORANGE)

HIGH (VILOET)

MAIN SPEED

POTENTIOMETER

(FRONT VIEW)

LOW (WHITE)

FIGURE 5 – MAIN SPEED

POTENTIOMETER CONNECTION