User Guide

B. Removing Terminal Block
TB1 from the KBMG
Remove terminal block TB1 from
the KBMG by rocking it back and
forth or using a screwdriver to gen-
tly pry it off. See figure 5 on page
9. The removed terminal block
TB1 will not be used and may be
discarded.
C. Modifying the KBMG Finger-
Safe Cover
Once the KBMG finger-safe cover
is removed, it has to be modified to
accommodate the SIMG. Cut out
the finger-safe cover panel
at seven (7) places as
shown in figure 6 on page
9. (Note: Some finger-
safe covers may already
have the panel removed.)
To access the field termi-
nals (F+ and F- on the
KBMG) cut out the field
tab of the KBMG finger-
safe cover at three (3)
places as shown in figure
7 on page 9.
7
FIGURE 3 – KBMG/SIMG ASSEMBLY DIAGRAM
Snap on cover
(4 places)
SIMG
Finger-Safe Cover
6-32 x 1-3/4" Screws
(2 places)
5-40 x 5/16"
Screws
(2 places)
Cable
Assembly
Note:
Yellow to F+
Brown to F-
SIMG
KBMG
Finger-Safe Cover
KBMG