User Guide

D. Installing the KBMG Finger-
Safe Cover
Once the KBMG finger-safe
cover has been modified, it
can be installed onto the
KBMG. Initially, use only the
two (2) 5-40 X 5/16” socket
head screws, using the sup-
plied 3/32” hex key. Do not
over tighten these screws or
damage may result to the
KBMG finger-safe cover.
Note: All jumpers on the
KBMG must be set to their
appropriate positions
before installing the
KBMG finger-safe cover.
E. Installing the SIMG onto
the KBMG
The terminal block located
on the bottom of the SIMG
plugs onto the six (6) header
pins where TB1 was
removed from the KBMG.
The two holes on the back of
the SIMG snap onto the fin-
ger-safe cover.
8
KBMG
Finger-Safe
Cover
KBMG
5-40 x 5/16"
6-32 x 1-3/4"
Screws
FIGURE 4 – REMOVING THE KBMG
FINGER-SAFE COVER