User Guide

F. Wiring the SIMG to the KBMG

See figure 8 on page 10.

The SIMG is powered from the KBMG with a connector that is installed from the

SIMG CON2 to the KBMG F+ and F- terminals. The yellow wire connects to the

KBMG F+ terminal and the brown wire connects to the KBMG F- terminal. When the

field connector is properly installed the wires should cross over each other. See fig-

ure 9. If the connector is wired incorrectly, the SIMG PWR LED will not illuminate

and the control will not operate.

Note: It is recommended that these wires be twist-

ed at least three (3) times to help reduce noise.

FIGURE 9 – INSTALLING

FIELD CONNECTOR