Manual

INSTRUCTION AND SAFE1Y MANUAL
FOR
PA-63
DOUBLE ACTION - SEMI AUTOMATIC PISTOL
Even though you may be familiar or have had experience
with other firearms, each firearm is different. In order to
understand the basics of the PA-63, this manual should be
read in its entirety. Enrollment in an NRA-approved safety
course is encouraged if you are unfamiliar with firearms.
CAU'I10N
Failure to heed the warnings in this booklet may result in
serious injury to you or others, as well as damage to the firearm
or other propert)t
'lake note of the following warnings on gun handling before
attempting to use your pistol:
1. DON'T REIY ON YOUR GUN'S SAFETY.TREAT EVERY
GUN AS IF IT WERE LOADED AND RF.ADYTO FIRE.
2. NEVER CROSS A FENCE, CUMB A TREE OR JUMP A
DITCH WITH A LOADED GUN.
3. NEVER LOAD OR CARRY A LOADED GUN UNTIL YOU
ARE READY TO USE IT.
4. WATCH YOU MUZZLE SO THE OTHER FELLOW
DOESN'T HAVE TO.
5. KEEP GUNS AND AMMUNlTJON SEPARATELY AND
IN A LOCKED STORAGE.
6. DON'T SHOOT UNLESS ABSOLUTELY SURE OF
YOUR TARGET AND WHAT IS BEYOND IT.
7. KNOW THE RANGE OF YOUR GUN.
8. AIJ1IAYSWEAR EYE AND EAR PROTECrION WHEN
SHOOTING.
9. AIJ1lAYS BE SURE THE BARREL IS CLEAR OF
OBSTRUCTIONS AND ONLY CARRY AMMUNITION
SPECIFlCAU.Y INTENDED FOR 1HE GUN YOU ARE
USING.
10. AJJ1lAYSCARRY HANOOUNS wrrH TIlE HAMMER
DOWN ON AN EMP1YCHAMBER.
AMMUNmON
SP.BC1P.ICA11ONS
BUUEf
CALIBER WEIGHT
.3a) ACP:9 rom Short 9SGR FMJ
FMJ =
Full metal Jadceted Bullet
MUZZLE
VELOCfIY
955 FPS
AMMUNmONWARNING
Use only original, high quality. commercially manufactured
ammunition which is in good condition. Only use ammunition
of the caliber for which your pistol is chambered. You will find
the correct caliber engraved on the sJide of the barrel. Never use
ammunition of any other caliber. You should always use
ammunition that complies with performance standards
established by The Sporting Arms and Ammnuition
Manufacturers' Institute, Inc.
The use of hand loaded, reloaded or other non-standard
ammunition will void all warranties.
DISASSBMBLY
The PA-63 pistol can be disassembled into 3 main components
in a few seconds without any tools. No further disassembly is
required or recommended for cleaning purposes. With the
safety "on", remove the magazine. Pull the tri@8ef guard
downward and to the side allowing it to rest on the frame. With
trigger guard held in this position, pun the slide all the way to
the end of its travel. Lift slide up and otrofthe fume and allow
it to ease fOrW'3fd over the barrel. Note: Never leave the
hammer fall forward on the frame while the gun is dismanded.
Damage may be done to the internal parts.
The trigger guard may be replaced to its normal position after
disassembly. The recoil spring may be removed for cleaning
purposes (small end goes around barrel).
ASSEMBLY
With the safety "on" and the hammer cocked. pull the trigger
guard downward and to the side allowing it to rest on the ffame.
Holding the tri8ger -guard in this position you can now replace
the sJide. Place the end of the recoil spring in the slide and puJl
the slide back to the end of its travel. Push it flat down on the
frame allowing it to slide forward to its normal position on the
frame. Return the trigger guard to its normal position.
OPERATION
SAFETY
The safety lever is on the left side of the slide. It is "on" when
the lever is turned down to cover the red dot; it is "off" when
the lever is turned up exposing the red dot. The safety lever
locks the firing pin, shields the firing pin, and uncocks the
hammer. (If it's already uncocked, keeps it &om being cocked.)

Summary of content (4 pages)