User's Manual

User Manual

Date 2018-10-01

Rev 1.4

2.3. How to Use

① Select the serial port through the serial port drop down menu.

If it is connected via USB, Magconn™ cable, or Bluetooth, a port that can connect with the

device program will be created. (The port number may differ from the illustration below)

② Press the Open button and the connection will be changed as shown below.

(Open Port button to Close Port button on)

③ You can select the command to transfer to device from RSP command list. Please refer to the

"RSP Interface Programmers Guide" for command and detailed explanation.

④ You can input Command directly from the Input Command drop down menu.

[Note] You can use the Command only if the serial port is properly connected.

[Note] Program’s General Commons > “Open_Comm” command must be executed first.

⑤ Commands can be sent to the device through the command transfer button.

⑥ You can check the result of command transmission /reception from “Transmit / Receive” window..

⑦ Through RSP command property window, ③ Properties for command selected in RSP

command list are displayed. Parameter properties can be changed by the user.

⑧ Explanation of the command selected in the RSP command list is displayed through the RSP

command description window..

⑨ Receive data window ⑥ Transmit / Receive data window can be cleared by the clear button.