Product Guide
Table Of Contents
- Revision History
- 1 Product Overview
- 2 Product Specifications
- 2.1 IoT HUB
- 2.1.1 Mechanical Specifications
- 2.1.2 Electrical Specifications
- 2.1.3 Environmental Specifications
- 2.1.4 Wireless Radio Specifications
- 2.1.5 Input Options
- 2.1.6 Part Numbers
- 2.2 Wired Vibration Sensor
- 2.2.1 Mechanical Specifications
- 2.2.2 Environmental Specifications
- 2.2.3 Acceleration
- 2.2.4 Temperature Sensor
- 2.2.5 Part Numbers
- 3 Installation and Setup
- 4 Product Support, Warranty, and Certification Information
IoT HUB Product Guide v.1.0
Lasted Edited: 05/04/2020
14 | Page
SELLER’S LIABILITY FOR ALL CLAIMS, WHETHER BASED ON BREACH OF CONTRACT,
NEGLIGENCE, PRODUCT LIABILITY, OR OTHERWISE, SHALL NOT EXCEED THE PRICE
PAID BY BUYER FOR SUCH DEFECTIVE PRODUCT. IN NO EVENT WILL SELLER BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (INCLUDING, WITHOUT
LIMITATION, LOSS OF USE, LOSS OF PROFIT, AND CLAIMS OF THIRD PARTIES),
HOWEVER CAUSED, WHETHER BY THE NEGLIGENCE OF SELLER OR OTHERWISE.
4.3 Certification Information
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. This
equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and any part of your body. Changes or modifications not expressly approved
by KCF Technologies could void the user’s authority to operate the equipment.
INDUSTRY CANADA STATEMENT
The term IC before the Certification/Registration number only signifies that the Industry Canada
technical specifications were met. This device complies with Industry Canada’s license-exempt
RSSs Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareilsradio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment complies with the IC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
20cm between the radiator and any part of your body.
FVIN: 3.2.0