Product Guide
Table Of Contents
- Revision History
- 1 Product Overview
- 2 Product Specifications
- 2.1 IoT HUB
- 2.1.1 Mechanical Specifications
- 2.1.2 Electrical Specifications
- 2.1.3 Environmental Specifications
- 2.1.4 Wireless Radio Specifications
- 2.1.5 Input Options
- 2.1.6 Part Numbers
- 2.2 Wired Vibration Sensor
- 2.2.1 Mechanical Specifications
- 2.2.2 Environmental Specifications
- 2.2.3 Acceleration
- 2.2.4 Temperature Sensor
- 2.2.5 Part Numbers
- 3 Installation and Setup
- 4 Product Support, Warranty, and Certification Information
IoT HUB Product Guide v.1.0
Lasted Edited: 05/04/2020
7 | Page
2.1.6 Part Numbers
The following variants are available for The HUB. Please use the complete part
number for all components to ensure the correct product and configurations are
shipped.
SD-HUB-1-[magnet][power]
Magnet Options:
Power Module Options:
Magnet:
M
Battery:
B
No Magnet:
X
120-240VAC:
A
Examples:
Hub w/magnets and battery module: SD-HUB-1-MB
Hub w/magnets and AC module: SD-HUB-1-MA
Hub w/out magnets and battery module: SD-HUB-1-XB
Hub w/out magnets and AC module: SD-HUB-1-XA
2.2 Wired Vibration Sensor
2.2.1 Mechanical Specifications
2.2.2 Environmental Specifications
Storage Temperature Range:
-40ºC to 125ºC (-40ºF to 257º F)
Operating Temperature Range:
-40ºC to 125ºC (-40ºF to 257º F)
IP Rating:
IP69
Hazardous Certification:
Class 1, Division 2 (planned)
2.2.3 Acceleration
Range:
+/- 19 g typical, +/- 16 g nominal
Resolution:
0.866 mg nominal
Noise Floor:
1.496 mg RMS @64 Hz /
13.01 mg RMS @ 8192 Hz
Transverse Sensitivity:
10% typical
Frequency Response:
+/- 5% 0-2700 Hz
+/- 3% 2700-4000 Hz
Samples per Acquisition:
4096
Spectral Lines:
2048
Anti-Aliasing Filter:
4000 Hz low-pass cut-off, 3
rd
order Sallen-Key
Sampling Frequency:
64 Hz – 8192 Hz configurable
Weight:
100 g
Enclosure Material:
Radel R5800 and 303 Stainless Steel
Mounting:
Maximum Mounting Bolt Torque:
Magnetic or Hard Mount, #10 or M5 Socket Head
30 in⋅lb max [3.4 N⋅m]