User's Manual


©2014KCodesCorporation.Allrightsreserved.6Seriesv2User’sManualV1.0

4.2.5. Auto-ConnectPrinter
Themethoddescribedinsection4.2.4isso‐calledmanual‐connect,whichmeansusersmustmanually
connecttheUSBdevicebeforeusingthatdevice,andmustmanuallydisconnecttheUSBdeviceafter
usingthedevice,otherwisenobodyelsecanconnectthisdevice.However,forprintersandscanners(and
MFPs),theUSBdeviceserversupportsauto‐c
onnectsousersdon’tneedtomanuallyconnect/disconnect.
Thisandthenextsectionsshowyouhowtodothis.
Afterthedriverisinstalledasdescribedinsection4.2.3,youcanseeanewlycreatedprinterinthe
ControlPanel’s“PrintersandFaxes”.FollowthestepsbelowtodoaNetUS
Bauto‐connectprinting.
1. IntheControlCenter,clicktheUSBdeviceserverthathasthedesiredprinter(orMFP)attached.
2. Clickthedesiredprinter(orMFP).
3. Clickthe“AutoConnectPrinter”buttonandchoose“SetAuto‐ConnectPrinter”.

Thefollowingfigurewillappear.