Owner manual

84
Appendices
KDS Legato 200 Series User’s Manual
KD Scientific Legato 200 Series Syringe Pump User’s Manual
Publication 5617-002-Rev F
R
S-485
1
2
34
5
6
Pin # RS-485 In Signal RS-485 Out Signal Notes
1 PWR IN PWR OUT (+30V)
*
2 GND GND
3 RS-485 A TIED TO PIN 4
*
*
4 RS-485 B TIED TO PIN 3
**
5 TIED TO PIN 6
**
RS-485 A
6 TIED TO PIN 5
*
*
RS-485 B
Mating Face
*
Protected by
resettable fuse
**
100 Ω, ½ w to
GND termination
RS-485 In/Out - IEEE-1394 Sockets
Daisy-Chaining via RS-485
P.C.
PUMP
ADDR Ø
USB or
RS-232
D
-Sub 9
F/F Cable
U
SB or
RS-232 IN
D-Sub 9
RS-485
OUT
PUMP
ADDR 1
R
S-485
OUT
RS-485
IN
PUMP
ADDR n
RS-485
IN
R
S-485
I
EEE 1394
C
able
RS-485
• • •
IEEE 1394
C
able
!
CAUTION:
DO NOT CONNECT TO FIREWIRE PORTS ON A PC. DAMAGE MAY
OCCUR TO PUMP AND/OR PC.
phone
508.429.6809 fax [phone]
e-mail [e-mail] web www.kdscientific.com
✐
NOTE: When applying power to pumps in a daisy chain, apply power to the last group in the chain first
and work backwards.
✐
NOTE: When removing power, be aware that power removed from a stand-alone unit will cause power to
be removed from all RS-485 powered units deriving power from that stand-alone unit.
✐
NOTE: Power may be removed from any group of pumps, except the first group, without affecting
communications “downstream”
✐
NOTE: Each pump in the daisy-chain must have a unique address. The first pump must be set to address 00.
✐
NOTE: When daisy-chaining with RS-485, at a minimum, every 4th pump in the daisy-chain must be
self-powered (i.e. another stand-alone unit). This can be affected by force selection.
RS-485 Das
iy Chain Connec
tion Options
:
If
a
ll pumps
ha
v
e s
of
twa
r
e v
ers
ions
2.0.0 or
higher, 99 pumps
in c
ha
in.
•
If a
ll pumps
ha
v
e s
oftwa
r
e v
ers
ions
1.0.6 or lower, 99 pumps
in c
ha
in.
•
If
mix
of
pumps
wit
h s
of
t
wa
re v
er
s
ion 1.0.6 or
lower
a
nd 2.0.0 or
higher, ma
x
imum of 5 pumps
in c
ha
in
•
a
nd 1
RS-485 a
da
pt
er
(c
a
t
a
log # 78-8339) r
equir
ed.
✐
NOTE: If a larger chain of pumps with mixed software versions is desired, pumps with software
versions 1.0.6 or lower can be returned to manufacturer for a hardware update.