User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety notes
- 3 General product description
- 4 Mounting and installation instructions
- 5 Show, connections and wiring
- 6 Installation
- 7 Operating behavior
- 8 Demo application
- 9 Function interface of device driver
- 10 Diagnosis
- 11 Maintenance and repair instructions
- 12 Disposal
- 13 Technical data
- 14 EC directives and standards
Operating behavior Kemro UserID classic / eco
48 User's Manual, Version: 1.01
© KEBA 2008
7 Operating behavior
7.1 Start-up behavior
During the startup of the Kemro UserID module, states are displayed in
the following order by the status LED:
Step Display Description
1 off (continuous)
Only for Kemro UserID eco:
Module from device driver not yet detected and swit-
ched on.
Only for Kemro UserID classic:
Once the module is supplied with voltage, the status
LED lights up red and the firmware is loaded (step 2)
2 red (continuous)
Firmware is loaded
3 orange (continuous)
Firmware is loaded, data communication with device
driver on the host system is established
4 green / orange
(blinking)
Supply and data communication with device driver on
the host system exists
After completion of the startup, the LED can either be set individually by the
driver or through a communication interface by the application (see chapter
Activation modes for status LED).