User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety notes
- 3 General product description
- 4 Mounting and installation instructions
- 5 Show, connections and wiring
- 6 Installation
- 7 Operating behavior
- 8 Demo application
- 9 Function interface of device driver
- 10 Diagnosis
- 11 Maintenance and repair instructions
- 12 Disposal
- 13 Technical data
- 14 EC directives and standards
User Identification System Function interface of device driver
User's Manual, Version: 1.01 67
© KEBA 2008
9.2.5 Data structure TModuleSettings
This data structure is used for reading and writing the setting data of an
RFID module.
Data element Euromap
65 ID #
Description
DWORD TModuleSet-
tings::dwInventoryRequestCycle
--
Cycle time for searching the new
transponders
DWORD TModuleSet-
tings::dwLedControlMode
--
Specification of who controls the
LEDs (default: 0):
• 0: driver takes over control.
• 1: the application takes over
control.
BOOL TModuleSet-
tings::boolCheckValidation
--
Specifies whether the validity of
the transponder is checked ac-
cording to Euromap 65 regulation.
unsigned short TModuleSet-
tings::usSafetyKey
--
Safety key for Euromap 65 encod-
ing
This key is used to together with
the data content of the trans-
ponder to calculate the safety
code.
DWORD TModuleSet-
tings::dwBaudrate
--
Baud rate of the Bus connection
for to the Kemro UserID mod-
ule
Note:
Only valid for units with serial
interfaces (Kemro UserID
classic).
9.2.6 Data structure TRfidDeviceName
This data structure is used in connection with the device name of a
Kemro UserID module.
Data element Euromap
65 ID #
Description
char TRfidDevice-
Name::strDeviceName
--
Name of Kemro UserID
modules