User manual

Installation
20/48
4.3 Preparingthecableinsertion
Therearetwopossibilitiesavailableforthecableinsertion:
● Cableinsertionfromabove(surfacecablerouting)
● Cableinsertionfrombelow(flushtypecablerouting)
Preparations
Removetheconnectorpanelcover(seeChapter"4.2.2Removingtheconnectorpanelcover").
Fitthechargingstationwiththerequiredcableglandsordummyscrewfittings(ifanopencable
insertionopeningisnolongerused).
Breakingoutthecableinsertionopenings…
Placethehousingonastablesupportpadanduse
ahammerandflatheadscrewdrivertocarefully
breakouttherequiredcableinsertionopenings.
Theninsertthecorrespondingfeedthroughs(cable
glandordoublemembraneseals)
4.3.1 Cableinsertionfromabovesurfacecablerouting
A ...CableglandM32(powersupplyline) B ...CableglandM16(forcontrolline/Ethernet)
C ...CableglandM16(forcontrolline/Ethernet) ...