User manual

Installation
30/48
4.5.4 Switchcontactoutput[X2](excludingeseries)
Theswitchcontactoutput(signalcontact)isapotentialfreerelaycontactandsignalsafaultfortheinternal
contactor.Iftheoutputisused,thecorrespondingDIPswitchsettingmustbeselected.
Circuitdiagram:
Electricalrequirements:
● SafetyextralowvoltageVcc<50VAC
● F≤0.5Acurrentlimitingprotectiveequipment
Connection:
Connectthewirestotheswitchcontactoutput(pleaserefertothechapter"4.5.5Terminals[X1/X2](ex
cludingeseries)").
DIPswitchsetting…
Theuseoftheswitchcontactoutputmustbeactivated
byaDIPswitchsetting.
Useswitchcontactoutput:
● "Yes":DSW1.2=ON
● "No":DSW1.2=OFF(Default)