User manual

Installation
38/48
4.7.2 Safetychecks
Beforetheinitialuse,checktheeffectivenessofthesafetymeasure(s)ofthesystemaccordingtothenation
allyapplicableregulations(e.g.:ÖVE/ÖNORME8001661,DINVDE0100600:200806"Checks,...")!
Electricalsystemsordevicesmustbecheckedbytheinstallerofthesystemordevicebeforetheirinitialop
eration.Thisalsoappliesfortheexpansionormodificationofexistingsystemsorelectricaldevices.
However,itisessentialthatallconditionsforthesafetymeasuresareobserved.
Moreover,thefollowingpointsaretobetakenintoaccount:
Thechecks(continuityoftheconnectionsoftheprotectiveconductor,insulationresistance,RCD(FI)
triggeringcurrent,triggeringtime,…)aretobeperformedfortheexpandedormodifiedpart.
Themeasurementdevicesmustcomplywiththenationalregulations!
(e.g.:DINEN60557(VDE0413)"ElectricalsafetyinlowvoltagedistributionsystemsuptoAC1000V
andDC1500V“).
Themeasurementresultsaretobedocumented.Atestreportistobecreatedandsavedbeforethe
check.