User manual

Installation

19 / 48

4.2 Preparing the cable insertion

There are two possibilities available for the cable insertion:

 Cable insertion from above (surface cable routing)

 Cable insertion from behind (flush-type cable routing)

Preparations

► Remove the connector panel cover (see Chapter "Removing/mounting the cable panel

cover").

► Populate the charging station with the required cable glands or seals (if an open cable

insertion opening is not used any more).

Breaking out the cable insertion openings

► Place the housing on on a stable support

pad and use a hammer and flathead

screwdriver to carefully break out the

required cable insertion openings.

► Then insert the corresponding

feedthroughs (cable glands or double-

membrane seals)