User manual

Installation

22 / 48

Marking the holes

► Mark the four holes [1] to [4] using the

supplied drilling template and a spirit

level.

► Drill the four mounting holes.

Information about the drilling template:

 The drilling template shows the outer contour of

the charging station.

 The four main mounting holes are aligned cen-

tered to the slotted holes on the device.

 The three holes in the upper right show the area

for the cable insertions and help to be able to

align the mounting position of the device to the

cables.

 The two notches on the top side are used for

aligning the device to the connection lines.

 In the lower part, the holes for the optional cable

hanger can be drilled appropriate to the device.

This part can be separated if the cable hanger is

not mounted or is to be mounted at a different

location.

Water drainage

The water drainage from the top side to the rear

side of the charging station must be ensured.

Therefore, observe the following:

 Only a vertical installation of the charging

station is permitted.

 The charging station must be mounted at an

angle of 90° (no inclination is permitted!).