User manual

Installation

33 / 48

4.5 DIP-switch settings

Changes in the DIP-switch settings will take effect once the charging station has been restarted!

To do this press the [Service button] for 1 second or switch the power supply voltage off/on.

DIP-switches

The DIP-switches are used for the addressing

and configuring the charging station and are

located under the connector panel cover.

[DSW1]…configuration (upper DIP-switch)

[DSW2]…addressing (lower DIP-switch)

DIP-switch example

The figure shows for a better explanation, the

position of the DIP-switches for the ON and

OFF state.

INPUT/OUTPUT (DSW1) / ONLY FOR STANDARD MODE

Function

DIP-switch

Figure

External enable input [X1]

is used

D1.1

ON=yes

Switch contact output [X2]

is used

D1.2

ON=yes

SmartHome interface via UDP

(details see “UDP Program-

mers Guide”)

D1.3

ON=

enabled