User manual

Further technical instructions
41 / 48
5 Further technical instructions
5.1 Programming RFID cards (optional)
Programming the RFID master card
The authorization by an RFID master card is necessary for the programming. The
programming mode can be activated and deactivated using the RFID master card.
The first RFID card that is detected by the charging station will automatically be
stored as the master card.
► Hold the RFID master card to be programmed in front of the RFID sensor and wait for the
signal tone.
The RFID master card is now programmed. Keep this card in a safe place.
Programming RFID user cards
► Hold the RFID master card in front of the RFID sensor and wait for the signal tone.
► Hold the new RFID user card in front of the RFID sensor within 5 seconds and wait for the
signal tone.
► To confirm, hold the RFID master card in front of the RFID sensor again within 5 seconds
and wait for the signal tone.
The RFID user card is now programmed.
Deleting all RFID cards from memory
► Remove the housing cover and open the connector panel cover of the charging station.
► Press the [Service button] for 5 seconds.
All saved RFID cards (including the RFID master card) are now deleted.
► Now start again with the programming of the RFID master card.