User manual

Important information
7 / 48
1.2 Intended use
KeContact P20 is a "charging station" for the indoor and outdoor area at which electrically operated
vehicles can be charged (e.g. electric automobiles).
The charging station is designed for installation on a wall or in a floor-mounted column.
The respective national regulations must be observed with regard to the installation and connection
of the charging station.
The intended use of the device always includes the compliance with the environmental conditions
for which this device was developed.
The device was developed, manufactured, inspected and documented in compliance with the rele-
vant safety standards. Therefore, the products do not pose any danger to the health of persons or
a risk of damage to other property or equipment under normal circumstances, provided that the
instructions and safety precautions relating to the intended use are properly observed.
The instructions contained in this manual must be followed precisely in all circumstances. Failure
to do so could result in the creation of potential sources of danger or the disabling of safety devic-
es. Apart from the safety instructions given in this manual, the safety precautions and accident
prevention measures appropriate to the situation in question must also be observed.
Only electrical vehicles or their chargers may be connected. A connection of other loads (e.g. elec-
tric tools) is not permitted!
Due to technical or legal restrictions, not all variants / options are available in all countries.
1.3 About this manual
This manual is valid for devices of the type
 KeContact P20
Use of this manual
This installation manual is intended for qualified personnel only
1
.
The figures and explanations contained in this manual refer to a typical device design. The design
of the device may deviate from it.
Please refer to the "KeContact P20 User manual" for information and instructions about operating
the device.
1
Persons who, due to their special training, expertise, and experience, as well as knowledge of current standards, are
able to assess the work performed and the possible hazards.