User manual

Installation
18/44
4.2.2 Removing the connector panel cover
Removing the connector panel cover
Unscrew the four screws that mount the connector
panel cover and remove the connector panel cover.
Take the silica bag out of the terminal panel and
dispose of it properly.
4.3 Preparing the cable insertion
There are two options available for the cable insertion:
● Cable insertion from above (surface cable routing)
● Cable insertion from below (flush-type cable routing)
Preparations
Remove the connector panel cover (see Chapter "↪ 4.2.2 Removing the connector panel cover [18]").
Fit the charging station with the supplied cable glands or dummy screw fittings (if an open cable
insertion opening is no longer used).
Breaking out the cable insertion openings
Place the housing on a stable support pad and use
a hammer and flathead screwdriver to carefully
break out the required cable insertion openings.
Then insert the corresponding feedthroughs (cable
gland or double-membrane seals).