User manual

Installation
22/44
4.5 Electrical connection
4.5.1 Connection overview with opened connector panel cover
1 ... Mains connection phase conductor 1 T1 ... Service button
2 ... Mains connection phase conductor 2 LED ... Status LED (internal)
3 ... Mains connection phase conductor 3 X1 ... Enable input
N ... Mains connection N conductor X2 ... Switch contact output
PE ... Mains connection PE conductor X3 ... Ethernet2 connection (RJ45)
F1 ... Fuse holder X4 ... Ethernet1 connection (LSA+ terminals)
DSW1 ... DIP switch configuration X5 ... USB connection (P30 only)
DSW2 ... DIP switch addressing Gnd ... Ground for Ethernet1 connection terminals
Information for Ethernet connection
The Ethernet1 connection [X4] and Ethernet2 connection [X3] are connected in parallel on the cir-
cuit board and cannot be used at the same time. The connection that is not used must be un-
plugged.