User manual

Index
43/44
Index
C
Cable feed from the rear .................................... 19
Cable insertion from above - surface cable routing.
19
CE Declaration ................................................... 42
Charging station with charging cable ................... 9
Charging station with socket ................................ 9
Commissioning................................................... 34
Commissioning mode/self test ........................... 34
Communication with the electric vehicle PLC->Eth-
ernet (optional) .............................................. 38
Connecting the power supply line ...................... 23
Connection overview with opened connector panel
cover.............................................................. 22
D
Differing Z.E.-Ready / E.V. Ready requirements 13
Dimensions......................................................... 39
DIP switch settings ............................................. 31
Display.................................................................. 9
E
Enable input [X1] ................................................ 26
Ethernet1 connection [ETH] ............................... 29
F
Firmware............................................................. 35
G
General criteria for the site selection.................. 11
I
Installation .......................................................... 15
Installation requirements .................................... 16
Intended use......................................................... 7
K
Key switch .......................................................... 10
L
Line circuit breaker ............................................. 12
M
Mains disconnector ............................................ 12
Mounting the charging station ............................ 20
Mounting the connector panel cover .................. 36
Mounting the housing cover ............................... 37
P
Power supply line ............................................... 12
Preparing the cable insertion.............................. 18
Product description............................................... 8
Programming RFID cards................................... 38
R
Removing the connector panel cover................. 18
Removing the housing cover.............................. 17
Replacing the fuse.............................................. 38
Residual-current device...................................... 12
RFID sensor ....................................................... 10
S
Safety checks ..................................................... 35
Safety instructions ................................................ 5
Scope of delivery................................................ 15
Space requirements ........................................... 14
Switch contact output [X2].................................. 27
T
Technical data .................................................... 40
Tool list ............................................................... 16
U
USB connection.................................................. 35
Use of this manual................................................ 7
V
Validity.................................................................. 7
en