User manual

Authorization process

15/112

2.2 Programming RFID cards (optional)

Programming the RFID master card

The authorization by an RFID master card is necessary for the programming of RFID user

cards (currently max. 20 pieces). The programming mode can be activated and deactivated

using the RFID master card.

The first RFID card that is detected by the charging station will automatically be stored as the

master card.

Hold the RFID master card to be programmed in front of the RFID sensor and wait for the signal tone.

The RFID master card is now programmed. Keep this card in a safe place.

Programming RFID user cards

Hold the RFID master card in front of the RFID sensor and wait for the signal tone.

Hold the new RFID user card in front of the RFID sensor within 5 seconds and wait for the signal tone.

To confirm, hold the RFID master card in front of the RFID sensor again within 5 seconds and wait for

the signal tone. The RFID user card is now programmed.

Deleting all RFID cards from memory

Remove the connector panel cover from the charging station and press the [Service button] for 5 sec-

onds. All saved RFID cards (including master card) are now deleted.

Now start again with the programming of the RFID master card.

Deactivating the RFID function

Remove the connector panel cover from the charging station and press the [Service button] for 5 sec-

onds. All saved RFID cards (including master card) are now deleted.

The RFID function is deactivated if no RFID card is held in front of the sensor for the next 60 seconds.

After deactivation, the status LED changes from blue to green.

Activating the RFID function

Remove the connector panel cover from the charging station and press the [Service button] for 1 sec-

ond to initiate a restart of the charging station.

Now start again with the programming of the RFID master card.