User manual

Installation

31/44

4.6 DIP switch settings

Changes to the DIP switch settings only become effective after a restart of the charging station! To do this,

press the [service button] for 1second or switch the power supply voltage off/on.

DIP switches…

The DIP switches are used for the addressing and con-

figuring the charging station and are located under the

connector panel cover.

[DSW1]…Configuration (DIP switch up)

[DSW2]…Addressing (DIP switch down)

DIP switch example setting…

For better explanation, the figure shows the position of

the DIP switches for the states ON and OFF.

CONTROL FUNCTIONS OF THE CHARGING STATION

Function DIP switch Figure

External enable input [X1] is used (for de-

tails, see Chapter "↪ 4.5.3 Enable input [X1]

(excluding e-series) [26]".

D1.1 ON= yes

Switch contact output [X2] is used (for de-

tails, see Chapter "↪ 4.5.4 Switch contact

output [X2] (excluding e-series) [27]".

D1.2 ON= yes

Activate SmartHome Interface via UDP (for

details see “UDP Programmers Guide”).

Only available for c-series and x-series

charging stations.

D1.3 ON= yes