User manual

Installation
20/44
4.4 Mounting the charging station
Installation materials
The included installation material (excluding e-series) is suitable for cement, brick and wood (without an-
chors). For other surfaces, a suitable method of installation must be selected.
Depending on the device model or for special materials, the installation materials must be provided
by the customer. A proper installation is absolutely necessary and lies outside of the scope of re-
sponsibility of the KEBA AG.
Please also observe the following manufacturer instructions:
Instructions for placing anchors and bolts. Source: Fischer
Marking the holes…
Mark the four holes [1] to [4] using the supplied
drilling template and a spirit level.
Drill the four mounting holes.
Information about the drilling template:
● The drilling template shows the outer contour of
the charging station.
● The four main mounting holes are aligned centered
to the slotted holes on the device.
● The three holes in the upper right show the area
for the cable insertions and help to be able to align
the mounting position of the device to the cables.
● The two notches on the top side are used for align-
ing the device to the connection lines.
● In the lower part, the holes for the optional cable
hanger can be drilled appropriate to the device.
This part can be separated if the cable hanger is
not mounted or is to be mounted at a different lo-
cation.