Product Manual

3.4 Connecting the chain
1. Remove the 2 nuts on each side of the chain with a 17mm wrench.
2. Starting with the back side, slide
the threaded end of the chain through
the two holes in the back of the lifter
frame and insert the 2 nuts onto the
threaded end. Tighten with the wrench.
3. Insert the cotter pin into the end
of the threaded bolt and bend prongs
outward to secure.
4. Next, attaching the front side.
Check to make sure the hydraulic pump
is all the way down by turning the
release valve and pushing down on the
hydraulic pump chain guard.
5. Slide the threaded end of the
chain through the hole on the back of
the lifter carriage and insert the 2 nuts
onto the threaded end. Tighten with the
wrench.
6. Insert the cotter pin into the end
of the threaded bolt and bend prongs
outward to secure.
Installation Guide
9
1
2