Product Diagram

Issue department：Bedding Division
Date：
2017-05-03
Product Function
instruction
Author：
Ben
No：MC232SC
MC232SC
Version：
1.0
Page 5 of 6
5
1.13. ZERO G position function
Press and release ZERO G button on remote，the head and foot actuator moves to preset memory position，stop
when press any button；
This function takes effect only by pressing the corresponding button on the remote.
1.14. LOUNGE position function
Press and release LOUNGE on remote，the head and foot actuator moves to preset memory
position, stop when press any button；
This function takes effect only by pressing the corresponding button on the remote.
1.15. TV position function
Press and release TV on remote，the head and foot actuator moves to preset memory position,
stop when press any button；
This function takes effect only by pressing the corresponding button on the remote.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this de
vice may not cause harmful interference, and (2) this device must accept any interference received, including in
terference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s aut
hority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not insta
lled and used in accordance with the instructions, may cause harmful interference to radio communications. Howe
ver, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.