User Manual

90
Table of ContentsSetting UpWi-Fi StreamingUsing KEF Connect AppFAQ and Troubleshooting
LED indicator Status
The Primary Speaker cannot find the
Secondary Speaker wirelessly. Short
press the P/S pairing button (P) on the
back panel of the Primary Speaker to re-
establish connection.
Source button and
Volume Down button are blinking.
Cable Mode is enabled but the connection
between the speakers is not established.
Connect the inter-speaker cable to the
Primary/Secondary connection ports (T)
on the speakers.
Source button, Mute button and
Volume Down button are blinking.
Firmware update is in progress. Do not
unplug the power cables until the firmware
update is completed.
Source button and Volume Down button
are blinking alternately.
Firmware update failed. Do not press the
Reset button (R) on the Primary Speaker.
1. Pull the power cables from both
speakers.
2. Wait approximately 60 seconds.
3. Plug the power cables back to both
speakers.
4. Performthermwareupdateagainon
the KEF Connect App.
If the problem persists, please contact your
KEF dealer.
Source button and Volume Down button
are blinking slowly.