Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Introduction
- General Information
- In the Box and Unpacking
- Setting Up LS50 Wireless II
- Connection and Control Interface
- Wi-Fi Streaming
- Multi-Room Streaming
- Voice Control Over Mobile Device
- Playback with Bluetooth
- Playback with HDMI eARC input
- Playback with Coaxial Input
- Playback with Optical Input
- Playback with Auxiliary Input
- Using KEF Connect App
- Cleaning and Maintenance
- Disposal
- FAQ and Troubleshooting
- Appendix
- Quick Start Guide
- Connectivity Quick Guide
- Product Info
- Important Safety Information & Specs
78
Table of ContentsSetting UpWi-Fi StreamingUsing KEF Connect AppFAQ and Troubleshooting
LED indicator Status
Cable Mode is enabled but the connection
between the speakers is not established.
Connect the inter-speaker cable to the
Primary/Secondary connection ports (T) on
the speakers.
Source button, Mute button and
Volume Down button are blinking.
Firmware update is in progress. Do not
unplug the power cables until the firmware
update is completed.
Source button and Volume Down button
are blinking alternately.
Firmware update failed. Do not press the
Reset button (R) on the Primary Speaker.
1. Pull the power cables from both
speakers.
2. Wait approximately 60 seconds.
3. Plug the power cables back to both
speakers.
4. Performthermwareupdateagainon
the KEF Connect App.
If the problem persists, please contact your
KEF dealer.
Source button and Volume Down button
are blinking slowly.
There is a system error.
1. Pull the power cables from both
speakers.
2. Wait approximately 30 minutes.
3. Plug the power cables back to both
speakers to resume normal operation.
If the problem persists, please contact your
KEF dealer.
Note: System error may occur with
improper power connections. Do not use a
socket/outlet extender with the speakers.
TV icon, OPT icon and Mute button
are blinking.