Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Introduction
- General Information
- Safety
- In the Box and Unpacking
- Controls and Connections
- Status Indication (LED indicator)
- Setting Up the LSX
- Control Interface
- Playback and Streaming
- Cleaning and Maintenance
- Storage
- FAQ and Troubleshooting
- Resetting to Factory Default
- Specifications
- Disposal
- Appendix
- Owner's Manual
- Contents
- Introduction
- First Time Setup
- Controls & Connections
- Audio Specifications
- KEF Control App
- KEF Stream App
- Wi-Fi Operation
- Bluetooth
- Optical
- AUX & Analog Inputs
- Digital Signal Processor
- TIDAL
- Spotify Connect
- Roon
- Apple AirPlay 2
- Subwoofer Operation
- Updating the Firmware
- Care & Cleaning
- Troubleshooting Guide
- Appendices
- Trademarks
- Quick Start Guide
- Specs
- Maintenance Guide for Kvadrat Fabrics
- Safety Information
- Warranty Information
33
Table of ContentsSetting Up the LSXUsing the KEF Control AppPlayback and StreamingFAQ and Troubleshooting
3. Launch the KEF Control app. Go to “Recovery Mode” in “Settings”. Closely follow
the instructions before tapping “Next”.
4. Connect the LAN cable from your router to the network port [N] of the Master
Speaker. Then tap “Next”.
5. Connect the Master and Slave Speakers with the provided inter-speaker cable
through the “To Master/Slave” connection ports on the back of the speakers. Then
tap “Next”.
3. 4. 5.
6. Using a paperclip/pin, press and hold the factory reset button [R] on the back of
the Master Speaker.
7. Without releasing the factory reset button, connect the power cable to AC input
connector [A] of the Master Speaker until the LED indicators at the front of the
Master and Slave Speakers ash white, blue, purple and yellow. Then tap “Next”.
8. The KEF Control app will start searching for your speakers to resume the rmware
update process.
7. 8.