User Manual

K-MIX EDITOR
107
ROUTING SECTION
The Routing section of the channel strip is where panning and sending
audio to the aux outputs are handled.
MAINS
The mains (outputs 1 & 2) only have a single parameter in the routing
section — panning.
PAN KNOB
The mains pan knob sets the left/right panning of the signal going
to the main outputs.
• Full left (counterclockwise) sends to just output 1 (output 2 is
silent).
• Full right (clockwise) sends to just output 2 (output 1 is silent).
• A centered pan knob will send the channel’s signal to both
outputs 1 and 2 equally.
AUXES
In addition to panning, each of the aux output pairs (3–4, 5–6, 7–8) have two other parameters —
send level and pre/post.
PAN KNOB
The aux pan knobs set the left/right panning of the signal going to the aux output pairs.
• Full left (counterclockwise) sends to just the odd-numbered output — output 3 for aux 1,
output 5 for aux 2, and output 7 for aux 3.
• Full right (clockwise) sends to just the even-numbered output — output 4 for aux 1,
output 6 for aux 2, and output 8 for aux 3.
• A centered pan knob will send the channel’s signal to both outputs of the aux pair
equally.
SEND LEVEL FADER
The aux send level faders control the amount of signal being sent to the aux output channels.
• Raise a fader to increase the signal being sent to the aux output; lower the fader to
decrease the signal being sent to the aux output.
• Each of the three aux output pairs has its own send level fader. Remember, each aux is a
stereo pair: aux 1 = outputs 3–4; aux 2 = outputs 5–6; aux 3 = outputs 7–8.
PRE/POST SWITCH
The aux pre/post switches set whether audio is going to the aux outputs pre-fader or post-
fader. The audio is either tapped before or after the input channel’s volume fader.
• When set to “Pre”, the currently selected channel’s volume fader will have no effect on
MAIN
Pan
Send
Level
Send
Level
Send
Level
Pan
Pan Pan
AUX 1
AUX 2 AUX 3
ROUTING
POST
POSTPOST