User Manual

K-MIX EDITOR
12 2
5.2.5 – USB TAB
This tab is where all of K-Mix’s USB-related options are housed.
5.2.5.1 – USB PRE/POST SWITCHES
The USB pre/post switches are used to set where in the K-Mix signal path audio coming from and going
to a connected computer will be sent to and sent from.
• USB input (mixer to computer) and USB output (computer to mixer) can be set separately.
• Each of K-Mix’s eight channels can be set individually for both USB input and USB output.
• By default the pre/post switches will be set so that K-Mix’s USB I/O acts as a traditional audio
interface. Audio plugged into K-Mix’s inputs will go up USB to a connected computer. Audio from a
connected computer will go directly out K-Mix’s outputs.
USB INPUT (MIXER AUDIO TO COMPUTER)
Input channels 1–8 each have their own “USB Input” pre/post switch. The input pre/post switch
sets where in the signal path the audio from K-Mix gets tapped and sent up USB to a connected
computer.
• Pre = Beginning of the signal path, directly after the ADC and just before the DSP effects. Useful
for recording live inputs on the connected computer.
• Post = Toward the end of the signal path, just before the nal fader and mute on the output
busses. For the main output bus (outputs 1 & 2) this is also post-DSP and post-reverb return.
Useful for recording your output mix on the connected computer.
• By default, these switches are set to “Pre”.
All USB options are editor-only parameters. They may not be adjusted from the
mixer.
USB ROUTING
PRE PRE PRE PRE PRE PRE PRE PRE
POST POST POST POST POST POST POST POST
USB INPUT
CH. 1 CH. 2 CH. 3 CH. 4 CH. 5 CH. 6 CH. 7 CH. 8
CH. 1 CH. 2 CH. 3 CH. 4 CH. 5 CH. 6 CH. 7 CH. 8
(Mixer Audio to Computer)
(Computer Audio to Mixer)
USB OUTPUT
SAVE GLOBALS