User Manual

K-MIX HARDWARE
50
4.2.7 – MAIN
The [MAIN] button on K-Mix is used to enter “Mains Mode”, where you can set the audio
levels going to the main outputs, outputs 1 & 2.
This is the default mode of K-Mix; when powered on for the rst time it will be in this mode.
Plug in, turn up the faders, and sound will be going out the mains.
4.2.7.1 – WHAT DO THE CONTROLS DO?
FADER BEHAVIOR
In Mains Mode, faders 1–8 are used to control the amount of signal being passed to the main output
bus for input channels 1–8. The master fader is used to control the overall output level of outputs 1 &
2.
Move a fader up to increase the signal level; move it down to decrease the signal level.
The faders can also be used for muting and soloing channels using the {SHIFT] button.
ROTARY BEHAVIOR
The rotary controls are not used when in Mains Mode; their LEDs will be off and will not respond to
touch.
CHANNEL SELECT BUTTON BEHAVIOR
In Mains Mode, the channel select buttons are used to represent the current mute/solo state of
each channel. They do not respond to touch in this mode, they are merely for visual feedback. Each
channel select button can be in one of four states:
• Green = Normal (no mute, no solo)
• Red = Muted
• Yellow = Soloed
• Blinking Yellow = Both muted and soloed
4.2.7.2 – ADJUSTING AUDIO LEVELS
Adjusting audio levels is simple — just move the faders up or down.
• Moving a fader up increases the level.
• Moving a fader down decreases the level.
Faders 1–8 adjust the amount of signal getting sent to the main outputs (outputs 1 & 2). The master
fader adjusts the nal output level of the mains.
The output channels cannot be soloed, so the “Master” channel select button can
only be green or red.