User Manual

K-MIX HARDWARE
53
4.2.8 – AUX1
The [AUX1] button is used to enter “Aux 1 Mode”; here you can adjust audio send levels to
the rst pair of auxiliary outputs, outputs 3 & 4.
4.2.8.1 – WHAT DO THE CONTROLS DO?
FADER BEHAVIOR
In Aux 1 Mode, faders 1–8 are used to control the amount of signal being passed to the Aux 1
output bus (outputs 3 & 4) for input channels 1–8. The master fader is used to control the overall
output level of outputs 3 & 4
• Move a fader up to increase that channel’s send level.
• Move a fader down to decrease that channel’s send level.
• The “Master” fader can also be used for muting the aux output bus using the [SHIFT] button.
ROTARY BEHAVIOR
The rotary controls are not used when in Aux 1 Mode; their LEDs will be off and will not respond to
touch.
CHANNEL SELECT BUTTON BEHAVIOR
In Aux 1 Mode, the channel select buttons are used for adjusting the pre/post state of the aux send
for each individual channel.
• Press and hold a channel select button for 1 second to toggle between pre and post.
4.2.8.2 – ADJUSTING SEND LEVELS
Adjusting the aux send levels is as easy as moving the faders up or down.
• Moving a fader up increases the send level of the selected channel.
• Moving a fader down decreases the send level of the selected channel.
• Faders 1–8 adjust the amount of signal being sent from the input channels to the aux 1 outputs
(outputs 3 & 4).
• The “Master” fader adjusts the nal output level of the aux 1 outputs.
4.2.8.3 – PRE/POST SENDS
The aux sends for input channels 1–8 can each be set to function as a pre-fader send or a post-fader
send. The channel select buttons are used for changing and displaying their current state.
• Press and hold a channel select button for 1 second to toggle between pre and post; the channel
select button’s LED will change color when successfully toggled.
• Green LED = Post-fader
• Red LED = Pre-fader