User Manual

K-MIX HARDWARE
67
4.2.16 – VERB
The [VERB] button is used to enter K-Mix’s “Reverb Mode” — here you can adjust the reverb
settings for K-Mix’s global reverb send.
4.2.16.1 – WHAT DO THE CONTROLS DO?
FADER BEHAVIOR
In Reverb Mode, faders 1–8 are used to control the reverb “send level”, the amount of signal being
passed into the global reverb effect for input channels 1–8. The master fader is used to control the
overall level of the reverb that is mixed in to the main output bus, outputs 1 & 2.
• Move a fader up to increase the reverb send level for that channel.
• Move a fader down to decrease the reverb send level for that channel.
ROTARY BEHAVIOR
The four rotaries are used to adjust the global reverb’s settings.
• Rotary 1 = PreDelay
• Rotary 2 = Damping
• Rotary 3 = Diffusion
• Rotary 4 = Decay
Rotaries act like traditional knobs; the minimum value is at 7 o’clock and the maximum value is at 5
o’clock.
• Move the rotary clockwise to increase the current parameter’s value.
• Move the rotary counterclockwise to decrease the current parameter’s value.
CHANNEL SELECT BUTTON BEHAVIOR
The channel select buttons are used for adjusting the pre/post state of the reverb sends.
• Press and hold any of the channel select buttons for 1 second to toggle between pre-fader and
post-fader.
The channel select button LEDs are used to represent the current state of the sends.
• Green = Post-fader
• Red = Pre-fader
4.2.16.2 – ADJUSTING REVERB SETTINGS
To adjust the reverb settings, do the following:
1. Press the [VERB] button to go into Reverb Mode.
2. Adjust any of the four rotaries to alter the reverb’s settings. The Rotary Control Indicator LEDs just
below the rotaries will light up to indicate what parameter each rotary is controlling.