User Manual

K-MIX HARDWARE

4.2.16.3 – ADJUSTING REVERB SEND LEVELS

To adjust the reverb send levels, do the following:

1. Press the [VERB] button to go into Reverb Mode.

2. Move faders 1–8 up to increase the amount of signal going to the reverb.

3. Move faders 1–8 down to decrease the amount of signal going to the reverb.

4.2.16.4 – PRE/POST SEND SWITCHING

To adjust whether the reverb sends are pre-fader or post-fader, do the following:

1. Press the [VERB] button to go into Reverb Mode.

2. Press and hold any of the channel select buttons for 1 second to toggle between pre-fader sends

and post-fader sends. The channel select button LEDs will be green when set to post-fader, and will

be red when set to pre-fader.

4.2.16.5 – [SHIFT] FUNCTIONALITY

The [SHIFT] button does not perform any reverb-related functions when in Reverb Mode. Pressing and

holding the [SHIFT] button does display the current mute/solo state of the input channels, but they

cannot be altered from this mode.

4.2.16.6 – NO REVERB WHEN SURROUND PANNING IS ENABLED

When Surround Panning Mode is enabled, the reverb will no longer pass to the main output bus

(outputs 1 & 2). Reverb mode is also completely disabled when surround is enabled; you will not be

able to access it via the [VERB] button.