User Manual

K-MIX HARDWARE

4.2.18 – +48V

The [+48V] button is used to adjust K-Mix’s phantom power settings.

Similar to the [BYPS] button, the [+48V] button must be held down while performing any

adjustments.

4.2.18.1 – WHAT DO THE CONTROLS DO?

FADER BEHAVIOR

The faders are not used when the [+48V] button is held down; they will not respond to touch and

their LEDs will be off.

ROTARY BEHAVIOR

The rotaries are not used when the [+48V] button is held down; they will not respond to touch and

their LEDs will be off.

CHANNEL SELECT BUTTON BEHAVIOR

While the [+48V] button is held down, channel select buttons 1 and 2 are used to toggle phantom

power on/off for their respective input channels. The channel select button’s LED is used to

represent the current phantom power state.

• Green = Phantom power on

• Red = Phantom power off

The master channel select button is used to toggle between +15V and +48V phantom power

voltage levels. The channel select button’s LED is used to represent the current voltage level being

provided by phantom power.

• Green = +48V

• Red = +15V

4.2.18.2 – TURNING PHANTOM POWER ON/OFF

To turn phantom power on/off, do the following:

1. Press and hold the [+48V] button.

2. Press channel select button 1 to toggle the phantom power state for channel 1. The LED will turn

green if phantom power is on, or red if phantom power is off.

3. Press channel select button 2 to toggle the phantom power state for channel 2.

4. Release the [+48V] button to return to the mode you were previously in.

When phantom power is turned on it will take a few seconds to fully ramp up to the

proper voltage level. The +48V LEDs above the master fader will blink while this is

happening.