User Manual

K-MIX HARDWARE

4.2.19 – PHONES

The [ ] button is used to enter “Phones Mode” — here you can adjust the headphone output

level and the headphone monitoring point.

4.2.19.1 – WHAT DO THE CONTROLS DO?

FADER BEHAVIOR

In Phones Mode, the master fader is used to adjust the nal output level of the stereo headphone

output on K-Mix.

• Move the fader up to increase the output level.

• Move the fader down to decrease the output level.

Faders 1–8 are not used in Phones Mode; they will not respond to touch and their LEDs will be off.

ROTARY BEHAVIOR

The rotaries are not used in Phones Mode; they will not respond to touch and their LEDs will be off.

CHANNEL SELECT BUTTON BEHAVIOR

Channel select buttons 1–8 are used to select one of the eight input channels as the monitor point

for the headphone output.

• Press any channel select button, 1–8, to monitor that channel’s input signal, pre-fader and post-

DSP.

The master channel select button is used to make the headphone output act as its own discrete

output, effectively adding an extra two outputs to K-Mix.

[MAIN], [AUX1], [AUX2], [AUX3] BEHAVIOR

In Phones Mode, the [MAIN], [AUX1], [AUX2], and [AUX3] mode buttons are used to select one of

the four stereo output bus pairs as the monitor point for the headphone output.

• Press the [MAIN] button to monitor the main output bus, the [AUX1] button to monitor the Aux

1 output bus, etc.

4.2.19.2 – ADJUSTING THE HEADPHONE OUTPUT LEVEL

Adjusting the overall level of the headphone output is simple:

1. Enter Phones Mode by pressing the [ ] button.

2. Move the master fader up to increase the output level; move the fader down to decrease the

output level.

3. That’s it! Press the [ ] button again to exit Phones Mode and return to the mode you were

previously in.