User Manual
K-MIX HARDWARE
74
4.2.20 – TEST TONE*
K-Mix’s test tone generator does not have its own mode button associated with it. It is instead enabled and
disabled by pressing and holding the [SHIFT] + [FINE] + [BYPS] + [VU] buttons for 2 seconds.
4.2.20.1 – ENABLING/DISABLING TEST TONE
To enable the test tone, do the following:
1. Press and hold the [SHIFT] button.
2. While the [SHIFT] button is still held down, press and hold the [BYPS], [FINE], and [VU] buttons.
3. Hold all four buttons for two seconds. All normal audio output will disable and the test tone will
now be going out all of K-Mix’s outputs.
Disabling the test tone follows the same process outlined above.
4.2.20.2 – CHANGING TEST TONE FREQUENCY
When the test tone is enabled, you may use the rotary controls to adjust the frequency of the tone being
output.
• Frequency Range = 40Hz – 4000Hz
• All four rotaries are linked, they will always be the same, regardless of which rotary is being
adjusted.
• The rotaries behave like a traditional knob; the minimum value is at 7 o’clock and the maximum
value is at 5 o’clock. Move the rotary clockwise to increase the current parameter’s value; move the
rotary counterclockwise to decrease.
* Available in a future update.