Manual

39
Figure 51: Be sure that the extractors are in the up position and that the rear of the bolt aligns with
the carrier before insertion into the receiver
Slide the Carrier Group forward until the slot for the charging handle is just past the edge of
the Grip Mount.
Figure 52: Align the hole on the carrier to the slot in the handguard to reinstall charging handle
Install the charging handle on the side you prefer. Now, pushing up on the bottom of the
Bolt and keeping it forward in the carrier gently slide the carrier group home. DO NOT
FORCE FORWARD IF RESISTANCE IS FELT! THIS WILL CAUSE THE BOLT TO JAM!
The Bolt should be pushed forward with the rear of the bolt aligning to the rear of the carrier
at all times.
40
Slide the Top Cover over the Bolt Carrier Group and Receiver. Pull out the Rear
Assembly Pins to their open most position. Slightly compress the Recoil Springs by
pressing against the Butt on the Top Cover and close the grip assembly. Look to see that
the holes of the Grip Assembly, Top Cover, and Receiver are fully aligned and push in the
Rear Assembly Pins. Cycle the action to verify proper function. The rifle is now assembled.
Note: Do not use excessive force on the Assembly pins!
Questions? Comments? Concerns?
If you need help in operating any of our products, have any questions about their safe
handling, need something repaired, or you just want to tell us what you think, please write
or email us at:
KEL-TEC CNC INDUSTRIES INC
1475 Cox Road
Cocoa FL 32926
Telephone Number: 321-631-0068
Toll free: 1-800-515-9983
Hours: M-F 8am-4pm EST
Website: http://www.keltecweapons.com/
Email: [e-mail]