Installation & Assembly

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
1. Shut off the power at the circuit breaker and remove old fixture,
including the cross bar.
3. Drill four holes in the wall, distance and the same distance from the
top holes of the mounting plate. Attach the mounting plate to the wall,
aligning the plastic anchors and junction box, lock it securely with the
four wood screws and the two box screws. The side of the mounting
plate marked ‘GND’ must face out. The junction box is not included.
4. In the mounting plate on the wall near the drill a hole, attach the right
angle shim to the wall, aligning the plastic anchors and lock it securely
with wood screw. The right angle shim can not go beyond the fringe
of the back plate.
5. Follow wiring instructions carefully (see fig.2)
6. Attach the back plate of the lamp body(F) onto the junction box,
aligning the back plate’s hole with mounting screw and lock it securely
with the hex nuts(G). Raise the glass shade(C) into the glass frame.
7. Install the light bulbs in accordance with the fixture’s specifications.
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
8. Attached the big finial(A) to the glass cover(B), lock it securely with
the hex nut(D). Attached the glass cover to the top(bottom) of lamp
body(F), lock it securely with the hex nut(C).
9. With silicone caulking compound, caulk completely around where
back of cover meets with the wall surface to prevent water from
seeping into junction box.
Wiring (see fig.2)
1. Connect the electrical wires as follows. Connect the
black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical
tape. If your outlet box has a ground wire (green or bare
copper) connect fixture’s ground wire to it. Otherwise
attach the bare copper fixture wire to the green ground
screw on the cross bar.
2.Tuck the wire connections neatly into the wall junction
box.
Fig.1
Fig.2
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
2. Carefully unpack new fixture and lay all the parts on a clear surface.
Take care not to lose any small parts necessary for installation.
ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT#
SERIES OUTDOOR WALL MOUNT LIGHT FIXTURE