Maintenance Handbook

SBS-800 Series Operator & Planned Maintenance Handbook
Chapter 7: Local Control
KH-1601-2 Issue 6
Page 47 of 80
7.2.3.2 Radar Control Status
Status Menu
Status
Radar
Control
Status
SharpEye
Network
NTP
Status
Comms
status
MISM
status
Software
Info
Exit
By scrolling through the radar control status menus, the following system configurations and settings
can be viewed but not adjusted.
A full description of each function is shown in the Control menu section 7.2.4.
Range mode
6nm (SBS-800-1,-2,-3 only), 24nm or 48nm
TX power
SharpEye™ Low or high power
TX frequency
Selected SharpEye
TM
transmission frequency (SBS-800-1,-2,-51) or
frequency pair (SBS-800-3) e.g. 12 to 21.
Mute
Indicates if the Mute is switched ON or OFF
SEA
Shows the configured value of the Sea filter
000 (minimum) to 255 (maximum)
RAIN
Shows the configured value of the Rain filter
000 (minimum) to 255 (maximum)
Int rejection
Function not used in SBS-800 systems (OFF)
Sweep
Shows if the sweep is set to Forward (default) or Reverse
RPM
Shows the selected control of the antenna motor (Off, Low, Auto or High).
When Auto is selected, the speed control is adjusted automatically to match
the range mode selected.
Rel sector 1
Relative sectors 1 to 4 will show Enabled or Disabled.
Blanking sectors can be set up to avoid obstructions or radar sensitive
equipment.
When Enabled, the start/stop bearings of the sector(s) are shown and the
RDU MUTE LED flashes.
Rel sector 2
Rel sector 3
Rel sector 4
Exit
Exits the Radar control status menu