Maintenance Handbook

SBS-800 Series Operator & Planned Maintenance Handbook
Chapter 7: Local Control
KH-1601-2 Issue 6
Page 48 of 80
7.2.3.3 SharpEye
Status Menu
Status
Radar
Control
Status
SharpEye
Network
NTP
Status
Comms
status
MISM
status
Software
Info
Exit
By scrolling through the SharpEye menus, the following system conditions can be viewed but cannot
be adjusted.
SharpEye
HL
Shows the antenna RPM based on HL frequency rate as
calculated by the RDU or FAIL if it is not present. .
Azimuth
Shows the value of the azimuth (e.g. 4096) or Fail if it is not
present
Video
Shows if the video is OK (present) or Fail if no signal is present.
Sync
Shows the current Sync value (PRF) or Fail if the level is below
the threshold set during commissioning or if no signal is present.
Blank
Shows if blanking is OK (present) or Fail if no signal is present.
Status 0: Mode 
Run Mode
Standby or Run.
Mute
ON or OFF.
Range
6nm (SBS-800-1,-2,-3 only), 24nm or 48nm.
Frequency
The SharpEye
TM
transmission frequency or
frequency pair.
Note
Alt Ch Plan
Only available for SBS-800-3 systems.
Sweep
Forward or reverse sweep.
Power
High or Low power.
RPM
Shows the RPM as detected by the SharpEye
TM
25us Pre sync
Enabled or Disabled the pre-sync from the
SharpEye
TM
transceiver.
Video range
Show the instrumented video range in µs.
Status 1: Alarm 
RX OK
Receiver OK or Fail
VSWR OK
VSWR OK or Fail – if Fail the transceiver
automatically switches to low power mode
TX power
Output power OK or Fail
PLO OK
Programmable local oscillator OK or Fail
SYNTH OK
SharpEye
TM
internal synth OK or Fail
Temp OK
Internal temperature OK, warning or shutdown
Turning OK
Antenna turning data OK or Fail
HL OK
Heading line OK or Fail
AZ OK
Azimuth in OK, Reversed or Missing
FPGA2 OK
FPGA 2 OK or Fail.
Status 2: GSR 
Sea
Sea clutter: 000 (minimum) to 255 (maximum)
Rain
Rain clutter: 000 (minimum) to 255 (maximum)
Int Rej
Not used in the SBS-800 series.
Doppler filter
No. of Doppler filters used e.g. 16, 32, 64 etc.
Status 3: VERS 
ZM number
SharpEye™ software number (e.g. ZM-2846)
Software
VERS
The version number of the software (ZM-xxxx)
FPGA version
Version of FPGA code loaded into the FPGA
Note: System dependant, please refer to the systems commissioning handbook reference KH-1601-
3 or the system integrator for the available frequencies.
Continued on following page