Use and Care Manual

ManualsBrandsKelvin ManualsHeating, Ventilation, and Air ConditioningVoice Interactive 7 Day Programmable Thermostat

Action Talking Products LLC

V1.7

Protected by U.S patent No. 5,690,277.

KELVIN

Operation Manual

KELVIN the voice interactive thermostat that speaks and

listens to you. By using simple voice commands you can

RAISE and LOWER the temperature in your home.

KELVIN the voice interactive thermostat also talks to you.

Helping you program the time and temperature to make your

home cozy and comfortable

Table of Contents

Getting Started ..............................................................................1

Button Functions............................................................................2

Display ..........................................................................................3

Setting the Time ...........................................................................3

Setting the Day .............................................................................5

Programming the temperture intervals .........................................5

Using Voice Commands................................................................8

Advance features...........................................................................9

Troubleshooting ..........................................................................11

Technical Information ..................................................................13

Summary of content (8 pages)

PAGE 1
KELVIN Table of Contents Operation Manual KELVIN the voice interactive thermostat that speaks and listens to you. By using simple voice commands you can RAISE and LOWER the temperature in your home. KELVIN the voice interactive thermostat also talks to you. Helping you program the time and temperature to make your home cozy and comfortable Action Talking Products LLC V1.7 All rights reserved. Protected by U.S patent No. 5,690,277. Getting Started .......................................................
PAGE 2
Button Functions Getting Started Warning: The electricity to your heating and cooling system should be turned off before attempting to install or remove any thermostat. Failure to do so could result in bodily injury and damage to equipment. Professional Installation recommended. Insert 4 AA batteries (not included) into the KELVIN thermostat as shown below. KELVIN will run on house current, batteries or both. It is set at the factory to run on both.
PAGE 3
Display Use the RAISE and LOWER buttons to set the hour. Each press will change the hour by one. When the hour is set press the SET TIME button again. The minutes digits will begin to flash. Use the RAISE and LOWER buttons to set the minutes. Finally press the SET TIME button a third time to save the time. Setting the Time Open the door to gain access to the programming buttons. Press and hold the SET TIME button until the thermostat says, “Set the time.
PAGE 4
Programming KELVIN SETTING THE DAY Press the MORNING interval button. This button is located under the door. The thermostat’s display will show the time of day and the day of the week that this interval will start. The display will also show what temperature is set for that time interval. Press the SET DAY button. The thermostat will advance one day on the display for each press of the SET DAY button. Keep pressing the button until the correct day is displayed.
PAGE 5
NOTE: It is important to remember to press the PROG button after you set your program because if you do not your settings will not be saved.
PAGE 6
-Air Conditioning (AC) Delay Advanced Features: This refers to a compressor delay for your AC system. The compress delay protects your AC system from short cycling. If your AC is turned off and then immediately turned back on again, it could potential damage your AC system. To avoid this the KELVIN waits 3 minutes before it turns the AC on again. This option can be disabled, but be careful. Consult your owner’s manual for your AC system, as this can cause potential damage.
PAGE 7
Troubleshooting Problem Heat not working AC not Working Cause Problem 1) Thermostat not set to heat Slide the Heat/Off/Cool switch to Heat. 2) Loose or bad connection to thermostat Verify that the thermostat is installed correctly and all of the connections are tight. Slide the Heat/Off/Cool switch to Cool.
PAGE 8
WARRANTY, TECHNICAL SUPPORT, AND COPYRIGHT INFORMATION Action Talking Products LLC. warrants this product to be free from defects in materials and workmanship for a period 1 year from the date of purchase to the original consumer purchaser. Its obligation under this warranty is limited to repairing or replacing, at its own sole option, any such defective products.