Operation Manual

Emergency operationChanging batteries and notices
6 Changing batteries/Energy operation Kelvinator Air Conditioning
1 Push the back cover of wireless remote control.
(As shown in Fig 1.)
2 Take out the old batteries.
3 Insert two new AAA1.5V dry batteries, and pay attention
to the polarity. (As shown in Fig 2.)
4 Attach the back cover of wireless remote control.
Note:
• Whenchangingthebatteries,donotuseoldorvaried
batteries, otherwise, it may cause problems with the
remote control.
• Iftheremotecontrolisnotusedforalongtime,please
remove the batteries as old batteries may leak or corrode
and damage the remote controller.
•
awayfromtheTVorstereoequipment.
• Forcorrectoperationtheremotecontrolshouldbe
placed within visible range of the air conditioner.
• Iftheremotecontroldoesnotoperatenormally,please
remove and refit the batteries. If abnormal operation
continues, replace with new batteries.
• Tooperatetheairconditioner,pleasepointtheremote
control at the indoor unit in order to improve the
sensitivity of the main unit.
1
3
4
2
Fig.1
Fig.2
Whentheremotecontrolislostordamaged,pleaseuse
the manual switch on the main unit. In that case, the unit will
operate in AUTO mode and the temperature setting or fan
speed can not be changed.
The manual switch can be operated as below:
AUTO SWITCH
Turn on the unit
Press AUTO/STOP button to enter AUTO mode.
The air conditioner will select the mode (COOL, HEAT,
FAN) automatically according to the room temperature for
reaching best comfort.
Turn off the unit
Press the AUTO/STOP button to switch off the unit.
The operation mode is seen in the following table.
Mode Model Temperature setting Airflow rate
AUTO COOLING 25°C (COOL, FAN) AUTO
AUTO HEATING PUMP 25°C (COOL, FAN) AUTO
AUTO HEATING PUMP 20°C (HEAT ) AUTO
This switch is to be used only when the remote control
is missing.
Toavoidinterference,theremoteshouldbeplaced1m