Users Manual

C. Mute mode
Press MUTE and 999 (S999 displayed) then press CALL, all charging pagers change to MUTE mode.
Press MUTE and 000 (S000 displayed) then press CALL, all charging pagers change to normal mode.
In MUTE mode, all pagers only vibrate and flash while being called.
Continuously press DELETE button (←) to return CALL mode. (C--- displayed)
D. Call History
Press ∨/∧ button to page up/down. When you find a number you want to call again, you can directly
press the CALL.
Continuously press DELETE button (←) to return CALL mode. (C--- displayed)
You can check up to 10 recent call history.
Note: No looping of ∨/∧.
E. One-Call-Off
In CALL mode, press 999 and CALL, all charging pagers will be off. Re-charge pagers will turn on
again.
Note: This instruction is invalid to the pagers not being charged.
F. Program Operation
All pagers are programmed before delivery. So this operation is only necessary when adding new
pagers or changing numbers.
Put the pagers on the charging base, press P and 999 (P999 displayed), then press CALL to enter
programming mode. The operation must be finished in 20 seconds after pagers are charged.
In programming mode, all LED display of the pagers will keep flashing.
Then input number and press CALL, all pagers display this number. Move the top pager away, the pager
will beep once and stop flashing. It means the pager is programmed.
Repeat the steps to program other pagers.
Note: The pagers will quit programming mode if no operation within 1 minute. All pagers’ numbers will
not change if not being programmed.
1 pager only can be programmed 1 number. Old number will be replaced by the new one.
4. Instruction Description
Instruction
Buttons
Display
Function
Programming Mode
P+999+CALL
P999
To enter programming mode
History
∨/∧
H + Number
Check recent 10 call records.
Mute Mode
+999+Call
S999
All charging pagers switch to MUTE mode.
Quit Mute Mode
+000+Call
S000
All charging pagers quit MUTE mode.
Call pagers
[Number]+Call
C+[Number]
The corresponding pager begin to remind.
5. Common Troubles and Solutions
Trouble
Analysis
Solution
The pager can’t be
programmed.
1.The pager is not being charged.
2.Charging is more than 20s.
1. Make sure the pagers are well charged.
2. Try again within 20s after recharging.
The pager can’t be
One-Call-Off
The pager is not being charged.
Make sure the pagers are well charged and
try again.
The pager doesn’t
response.
1. The pager is out of power.
2. Out of call range.
1.Use after full charged.
2.Use within range of call.