Datasheet
11© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC29606 • 864-963-6300 • www.kemet.com A4067_A750 • 8/29/2017
Single-Ended Conductive Polymer Aluminum Solid Electrolytic Capacitors
A750 105°C
Flow Soldering (not suitable for SMD parts)
The soldering conditions should be within the specied conditions below:
• Do not dip the capacitors body into the melted solder.
• Flux should only be applied to the capacitors terminals.
• Vapour heat transfer systems are not recommended. The system should be thermal, such as infra-red radiation or hot
blast.
• Observe the soldering conditions as shown below.
• Do not exceed these limits and avoid repeated reowing.
Flow Soldering
Temperature
(°C)
Maximum Time
(Seconds)
Maximum
Repetitions
Pre-heat <120 <120 1
Solder 260 ± 5°C <10 2